READ THROUGH CAREFULLY BEFORE OPERATION
The Autodialler will automatically send messages whenever the equipment to which it is connected goes into a FIRE or FAULT condition.
When the autodialler sends its message an indicator marked ALARM CONDITION on the front panel is illuminated.
To enable users to test their fire alarm systems without the autodialler sending either its fire or fault messages it is possible to disable the autodialler by turning the front panel keyswitch from NORMAL to ISOLATE.
On switching to ISOLATE, the two indicators marked ISOLATE flash alternately and a small internal sounder will bleep in sympathy.
This is to remind users that the system has been disabled.
As soon as the required tests have been performed on the fire alarm system and the fire alarm panel has been reset (All fault and alarm indicators have been extinguished), restore the autodialler back to its operational state by turning the keyswitch back to NORMAL.
This should extinguish all autodialler indictions other than SUPPLY ON.
Copyrght Evasafe Products Limited 1999-2006